Technician A says that too much clutch pedal free play can cause the clutch to shudder
during rapid acceleration. Technician B says that too little clutch pedal free play can
cause the clutch to slip. Which technician
...
Technician A says that too much clutch pedal free play can cause the clutch to shudder
during rapid acceleration. Technician B says that too little clutch pedal free play can
cause the clutch to slip. Which technician is correct? - ANS-tech b
A pickup truck equipped with a diesel engine has been towed to the shop. The engine
speed increases when the driver depresses the accelerator pedal and releases the
clutch pedal, but the vehicle does not move. Technician A says the clutch may be
defective. Technician B says the dual-mass flywheel may be defective. Which
technician is correct? - ANS-both
A squealing sound is heard and the sound changes when the driver exerts force on the
clutch pedal. Technician A says the pilot bearing is defective. Technician B says the
input shaft bearing is defective. Which technician is correct? - ANS-tech a
A clutch is chattering when engaged. Technician A says that too much clutch free play
is the cause. Technician B says that oil or grease may be on the friction disc. Which
technician is correct? - ANS-tech b
A manual transmission has gear grinding and is difficult to shift or get into gear,
especially reverse. Technician A says that the clutch may not be fully releasing.
Technician B says that too much clutch pedal free play could be the cause. Which
technician is correct? - ANS-both
Two technicians are discussing bleeding a hydraulic clutch. Technician A says to open
the bleeder and allow the fluid to gravity bleed. Technician B says to have an assistant
slowly depress the clutch pedal as the bleeder valve is opened at the slave cylinder to
bleed the air out of the system. Which technician is correct? - ANS-both
Two technicians are discussing a transmission that is difficult to shift into gear.
Technician A says the clutch may not be fully releasing. Technician B says that the
synchronizer rings (blocking rings) may be worn. Which technician is correct? - ANSboth
A new clutch has been installed and adjusted. This technician is attempting to rotate the
output shaft while an assistant depresses the clutch pedal with the transmission in
fourth gear (direct 1:1 gear in most units). What is the technician checking? - ANS-That
the clutch linkage is adjusted correctly to allow the input shaft to rotate
[Show More]
