Ladder must be installed if pit is deeper than... Correct Answer: 35" (3') ASME A 17.1 - 2004 2.2.4.2
Ladder shall not extend more than ___ above the sill. Correct Answer: 48" (4') ASME A 17.1 - 2004 2.2.4.2
Rung
...
Ladder must be installed if pit is deeper than... Correct Answer: 35" (3') ASME A 17.1 - 2004 2.2.4.2
Ladder shall not extend more than ___ above the sill. Correct Answer: 48" (4') ASME A 17.1 - 2004 2.2.4.2
Rungs (cleats or steps) of ladder should be a minimum of ___ wide. Correct Answer: 16" ASME A 17.1 - 2004 2.2.4.2
Siderails shall have a clear distance of not less than ___ from their centerline to the nearest permanent object. Correct Answer: 4.5" ASME A 17.1 - 2004 2.2.4.2
Ladder access shall not be permitted if pit is deeper than ___ below the sill of the access door. Correct Answer: 120" (10') ASME A 17.1 - 2004 2.2.4.2
Illumination of pit and platform should be___. Correct Answer: 10FC ASME A 17.1 - 2004 2.2.5.1
Where should the light switch be located in the pit? Correct Answer: Where accessible from the pit access door. ASME A 17.1 - 2004 2.2.6.1
When the car is on compressed buffer, what is the clearance between the car and the pit? Correct Answer: 24" (2') clearance. No part of the car should be touching the pit with a 24" (2') clearance. ASME A 17.1 - 2004 2.4.1.1
Where vertical clearances are less than ____", that area should be clearly marked on the pit floor. Correct Answer: 24" (2')
Markings should be___" diagonal red and white stripes "Danger low clearance." Correct Answer: 4"
When oil buffers are used, bottom runny should be no less than ___". Correct Answer: 6"
When spring or solid buffers are used, bottom runny should be no less than ___". Correct Answer: 6"
What is the maximum bottom runby on a car? Correct Answer: 24" (2')
Buffer data plate letters shall be no less than ___" in height. Correct Answer: 1"
What is the maximum bottom runby on a counterweight? Correct Answer: 35" (3')
What is the minimum sill to sill clearance? (side guides) Correct Answer: 1/2"
What is the minimum clearance for corner guides
[Show More]